NodeMCU DEVKIT dan Lua

[ [ images & links ] ]

pinout.pngGambar 1. NodeMCU [sumber]

https://i-esan.com/wp-content/uploads/2013/06/nodemcu_v2_pin_map.pngGambar 2. [sumber]http://c.tutti.ch/images/esp8266-nodemcu-v3-base-board-protoshield-mit-spannungsregle-6355190634.jpgGambar 3. NodeMCU + Base yang tidak memerlukan tambahan adapter [sumber]

Gambar 4. NodeMCU v0.9 pinout [sumber]

Perbedaan antara v0.9 dan v1.0:

If you are going to purchase a NodeMCU board it’s important to know there are two official versions:

  • NodeMCU v0.9 with ESP-12 module
  • NodeMCU v1.0 with ESP-12E module

The main complain about NodeMCU v0.9 is that while it fits on the breadboard, you can’t use as it takes the full width of the board, while NodeMCU v1.0 is really breadboard-friendly as you can see on the right part of the picture above.

Gambar 5.

Gambar 6.

Lakukan hardware reset pada nodeMCU DevKit, setelah menekan Connect pada Moserial.

Gambar 7.

Gambar 8.

Gambar 9.

Lakukan hardware reset pada nodeMCU DevKit, setelah menekan Open pada ESplorer.

Gambar 10.

Gambar 11.

Gambar 12. [ klik gambar untuk memperbesar tampilan ]

init.lua

Gambar 13.

Gambar 14. [ klik gambar untuk memperbesar tampilan ]

Gambar 15.

NodeMCU, Lua, Arduino IDE